This Kit includes an Aerosol of Rust Encapsulator, and FXLiner, Our Super tough Smooth Bedliner.
This kit will allow you to refinish everything from rusty crossmembers, to bumpers and powder coated winch bumpers and rock sliders.
1x 400ML Heavy Load Rust Encapsulator Aerosol for stabilising existing corrosion.
1x FXLiner Black satin smooth Aerosol to provide a hard, and durable top coat.
You can Achieve a smooth finish with light coats, or a slight texture if you lay FXLiner on a little heavier. Allow RCP to full cure for 24 Hours prior to top coat with FXLiner.
Use one Kit per rock slider, for Tuber sliders you may require more than one kit.
- Remove loose rust and existing paint
- Use Buzzweld Purge to clean the prepared surface of contaminants (included in kit) with a suitable cloth/scour and then wipe clean.
- Mask off and protect all surrounding areas and equipment
- using a steady motion spray from side to side until the first coat of RCP primer has fully covered the item. Leave until touch dry (10>30 minutes typically), and apply the second coat.
- Leave item to cure for 1>2 hours until product has hardened (in low temperatures, or poor ventilation this time can increase considerably)
- If corrosion pitting is evident use Oxide-X in the same motion as above to build the profile. Continue to do so until flat prior to top coating
- As above with the RCP use the top coat finishing aerosol to apply your first coat. Allow to touch dry for 5>20 minutes depending on conditions before applying your final top coat.
Note. Should the finish become contaminated with debris, or dust simply allow the finish to cure and lightly refinish with 240 grit wet and dry. Re apply once flat and dry.
- RCP Primer
- Your chosen top coat aerosol
- Aerosol Unblocker kit