100MM High Density Foam roller
Flocked foam gives a superior smooth finish with gloss, primers, varnishes and all oil and solvent based paints. For use on smooth or slightly textured surfaces...
The High density Foam is covered with a very fine short pile synthetic flock for an extra smooth finish.
Guaranteed no Fibre Loss.
Ideal use: Gloss, primers, varnishes and all oil and solvent based paints.
Surface area: Smooth or slightly textured surfaces.
|Average Rating (1 Review): |Best roller sleeves for CIO
Thursday, 11 June 2020 | Pamela
I had tried a few roller sleeves to use with the CIO coatings. I tried a normal foam roller and it completely warped it making it useless. Then tried a low nap microfibre and it just left fuzzy bits all over. Got them out but that was after trying to remove any lint beforehand. I then tried a fussy bloke roller and it did better but still had the odd fuzzy bit. CIO dries quickly and then dries on the rollers and I ended up with hard dried bits on the ends of my rollers. So I asked the owner of Buzzweld what he would recommend and it was the mini flocked sleeve. I bought 2 and they are by far the best roller sleeve for the CIO. I was able to paint my entire project with it not warping, it didn't leave a single fuzzy behind, it didn't dry out on the ends, held a good amount of paint, and rolled on very smoothly. If you are getting the CIO, get these to go with it! So happy with the quality of these. Thank you
Was this helpful to you? Yes / No
This review has not been appraised.