Buzzweld 06:30 > 14:30 mon> Fri
Crossmember & bumper Paint kits (aerosol)
Crossmember & bumper Paint kits (aerosol)

Crossmember & bumper Paint kits (aerosol)

£11.55
(Exc. 20% VAT)
(£13.86 Inc. VAT)
Earn 11 Loyalty Points
(12 Reviews)
+
Information

These kits include various paints.

All kits come with 1x 500ML Passive 8 90% Zinc Aerosol.

Gloss Black, and Satin black are out 500ML trade sprays.

DTM, and all 2K options are premium 400ML Aerosols.

Once activated the 2K aerosols can be reliably used up to 1 hour from activating

 
 
 
Preparation
  1. Remove loose rust and existing paint
  2. Use Buzzweld Purge to clean the prepared surface of contaminants (included in kit) with a suitable cloth/scour and then wipe clean.
  3. Mask off and protect all surrounding areas and equipment
Application
  1. using a steady motion spray from side to side until the first coat of Passive8 primer has fully covered the item. Leave until touch dry (10>30 minutes typically), and apply the second coat.
  2. Leave item to cure for 1>2 hours until product has hardened (in low temperatures, or poor ventilation this time can increase considerably)
  3. As above with the primer, use the top coat finishing aerosol to apply your first coat. Allow to touch dry for 5>20 minutes depending on conditions before applying your final top coat. 
Note. Should the finish become contaminated with debris, or dust simply allow the finish to cure and lightly refinish with 240 grit wet and dry.  Passive8 apply once flat and dry.
 
Contents.
  1. Passive8 Aerosol Primer
  2. Your chosen top coat aerosol
12 Reviews:

Excellent Robust Paint
Rating:
02 June 2024  | 

Very good paint and primer.
The primer was very easy to use, the Raptor ended up quite lumpy and has a bumpy/rippled effect which looks very rugged but not as smooth as i had hoped. Thankfully on the Land Rover it still looks more than appropriate

 
Was this helpful to you?  Yes  /  No

Nice kit
Rating:
16 May 2024  | 

Items as described, did a good job of tidying up the rear cross ember.

 
Was this helpful to you?  Yes  /  No

2k paint
Rating:
23 August 2023  | 

Great product, easy to apply if you follow the instructions and a good finish. Applied to my Defender cross member. Looks better than new.

2 of 2 people found this review helpful.
Was this helpful to you?  Yes  /  No

Land Rover Defender Cross Menber Re-paint
Rating:
14 June 2023  | 

You get 2 paint sprays in the kit but I didn't need the grey undercoat as the original paint was not that bad.
The buzzweld did a great job and the paint finish looks good.
The service and delivery from buzzweld was also fantastic so I would recommend it to anyone.

 
Was this helpful to you?  Yes  /  No

Cross member
Rating:
01 July 2022  | 

Great product easy to apply

1 of 1 people found this review helpful.
Was this helpful to you?  Yes  /  No

Passive 8 and Raptor 2k
Rating:
20 April 2022  | 

Excellent products with a real professional finish. Would highly recommend and would purchase again. Hopefully not too soon though. Used on a defender 90ís rear cross member

 
Was this helpful to you?  Yes  /  No

Great finish
Rating:
07 March 2022  | 

Very easily applied and leaves a great finish on the rear crossmember, fast delivery and well packaged.

 
Was this helpful to you?  Yes  /  No

Crossmember & bumper refurbishing
Rating:
18 July 2020  | 

Having read the product details prior to purchase and comparing with other similar offerings, the buzzweld kit was the one I selected.
Preparation was undertaken as recommended and the paints applied accordingly. I had no issues whatsoever and the completed job is exactly what I was hoping for.
Looking forward to years of no rust.

Excellent product.

 
Was this helpful to you?  Yes  /  No

Great product
Rating:
19 June 2020  | 

Used the rust encapsulater to my cross member which gives an excellent coverage and finish. This gives a great base for the FXLiner and creates a superb factory look finish. I left it to harden for a couple of days before rebuilding the back end and the surface was really tough. Will use again if required, the best coating I have used to gate, hopefully it will last longer, time will tell.

 
Was this helpful to you?  Yes  /  No

Crossmember kit
Rating:
12 April 2020  | 

Easy to apply to crossmember. Leaves a nice textured finish. Top quality product.

 
Was this helpful to you?  Yes  /  No

Read all 12 customer reviews...

Related Products

Aerosol Nozzles MEGA PACK 20x
£5.24
£9.99
(2)

Full Selection of nozzles x20

 

Consists of 

2x Unblocker Nozzles

6x LVLP wide fan nozzles

6x medium flow fan nozzles

6x very high flow round nozzles

IMPORTANT TERMS. Read before ordering.

Delivery & returns
DELIVERY

All orders are sent to be delivered to you or a neighbour. By Ordering you are accepting responsibility for the delivery location. If this is not acceptable then you MUST leave a note on your order specifying signature only. We do not ship all orders for signature as most people are not available all day to take delivery.We send all orders with DHL.

Cut off time for same day dispatch is 12pm.

Please supply a mobile number to assist the courier.
DHL will attempt delivery twice, after this you may be charged an addition fee.
All orders will only be sent if the billing address matches the card details.
Please ensure someone is available to receive the delivery.
We can not be held responsible for any delays caused by DHL.
If you need assistance with your delivery please call 01454315588. Our staff will be more than happy to help.


RETURNS

We offer a 30 day money back return policy on all goods returned in un-used condition and original packaging. Unfortunately we can not offer refunds or exchange on mixed colours or aerosols to order.

All items must be returned to qualify for a refund. Upon receipt of your item we will check the item and notify you if we are able to process a refund by phone or email within 3 working days.

Once we have despatched your goods (or if you have collected them), you can return them for a full refund (including standard delivery charges) within 30 days of delivery (or collection) without giving a reason, as long as they are with their original packaging and unused. You will be responsible for returning the goods to us (and have to pay any costs involved) and we are allowed to reduce your refund if there is any damage to the goods caused by you handling them. We will make all refunds to the credit card, debit card or PayPal account used to place your order and we will pay you within 14 days of us receiving the goods you have sent them back to us.


Colours

We will make your colour to specification, however, when added to different products the colours will be represented differently. As an example Ral3020 in Raptor, 2K Direct Gloss, Basecoat, and GIO side by side will all be DIFFERENT, even though they are made with EXACTLY the same tint. Variance issues are non refundable. Please call us if you have any concerns. We do also try and filter out these issues by inspecting your order. Metallic colours are strongly affected

Cancellations

All cancellations must be provided as soon as possible via phone contact only. We cannot always view emails / messages in a timely manner. Your order can be cancelled on 01454315588 mon>fri 06:30>14:30.  Custom orders such as non stock items, and colours are made to order. If you wish to cancel an order that has a custom item on it, and we have already made it, We will not be able to refund for that item because we cannot return it to "stock".

Brand
Buzzweld